According to the instructions of light touch switch manufacturers, the phase lines of electrical appliances and lamps should be controlled by switches. When switching wiring, the wires in the box should be straightened out. After wiring in turn, the wires in the box should be coiled into a circle and placed in the switching box.

There are two kinds of single-phase two-hole sockets: horizontal socket and vertical socket. When installed horizontally, the right pole of the socket is connected with the phase line, while the left pole is connected with the zero line; when installed vertically, the upper pole of the socket is connected with the phase line, and the lower pole is connected with the zero line.

(2) Grounding or zero wiring of single-phase three-hole and three-phase four-hole should be above.

Touch switch manufacturers warmly remind consumers that they should pay more attention when using various switches to avoid electric shock accidents.

Touch the switch manufacturer: first look at the protective door, with a screwdriver or small key to poke two holes on one side and three holes on the bottom of a random hole. With a little effort, a single-sided protection door can be pushed in, which is equal to No. The manufacturer of light touch switch tells you that this kind of socket is obviously not safe enough. Next, look at the materials used for copper parts. If you see it is bright yellow through the jack, just give it up. Brass is easy to rust, soft in texture, and its electrical conductivity will decrease after a long time of contact. If the color of copper sheet is purple-red, it is better. The copper sheet is tough and does not rust easily.